Device:Floppy Type=no disk PROBLEM

So i just installed a floppy drive in my mpc 2000 xl
I put a fresh floppy with samples in the mpc

http://imageshack.us/f/830/p11051113250001.jpg/

and it says ''no floppy device''
floppy drive has no light but it makes sounds
what's going wrong?

Help me please

floppy cable maybe needs to get turned around...

Based on what I see in the picture, the ribbon cable is installed correctly. What about the floppy drive - are you sure it is a compatible model? If so, are you sure that the floppy is functional?

scsicardreaders.com wrote:Based on what I see in the picture, the ribbon cable is installed correctly. What about the floppy drive - are you sure it is a compatible model? If so, are you sure that the floppy is functional?

I can't be sure about the floppy because it cames unplugg with the mpc when i bought it
So maybe the best i can is buy another floppy driver to verify??
In this case - i will wait for your advices

Could be the jumper settings.
I'll try and photograph the correct settings a bit later tonight (assuming what you have is an original mpc2000xl floppy drive).
If they have been changed it could stop it working properly.



EDIT:
here check your settings against this. Hope it's clear enough.

PROBLEM SOLVED thanks for support

apokaveli wrote:PROBLEM SOLVED thanks for support

Please tell us how you solved it, for future reference

My ribbon cable wasn't pushed up to the bottom of the slot.

\Ah great.
Glad it's sorted.

hey all, I'm having the same issue. I have checked the same cables and jumper settings to make sure that they are all pushed in and the jumper settings on the original floppy drive are correct...I am getting a no floppy device detected error message and a constant beep.....help please??