Installing mpcstuff pad corx on a MPC60II

I have some corx installed on my 2500 and they work well so now I'd like to put them in my 60II. I was wondering if anybody has any pictures of how to get to the pad sensors/underside of the pads or a step by step guide on what screws I need to remove and in what order. Thanks.

I think you have to unscrew the plastic top and once you carefully lift it up (lift from the front as it's connected by wires at the rear of the machine) then there should be some screws holding that panel to the lid.

Thanks, I'll give it a try tonight.