How to edit filter for only 1 zone

is there any way to edit the filter for just 1 zone of a drum pad?

For instance: I have 2 kicks on a pad. I want 1 kick to have a filter and the other kick to not have the filter. I made sure the edit zone was set to "ONE" and not "ALL" and it still applies the filter to both sounds. Is there any way around this? Is there a way to trigger 2 pads with 1??


EDIT: I figured out how to do the filter part, there is a filter setting in the program zone section. You can edit the send to the filter that way.. but what if I want to set the attack\decay\release for 2 different sounds???

Under EDIT1
above PITCH. in that top bar it says
EDIT:ONE ZONE:_: (then your sample)
if you change that blank to the zone you want to filter it should just filer it..
correct?
also I just found a sweet new smiley :_:
ALIEN!

Trickphotography wrote:Under EDIT1
above PITCH. in that top bar it says
EDIT:ONE ZONE:_: (then your sample)
if you change that blank to the zone you want to filter it should just filer it..
correct?
also I just found a sweet new smiley :_:
ALIEN!

no for me it seems to be filtering both zones instead of just the 1 zone I selected.

Most of the answers to things you are trying to find out are contained in the newbie bible sticky and the links to threads... sticky at the top ofthe page. Have a look through them you'll find out a lot about how to use the 4k.

Oh, and don't forget to look at the manual occassionally and to use the forum search function