Exchange tips and tricks for the Akai MPC4000
By gorgorsan Sun Aug 14, 2011 2:19 am
Hi, I put out memory module to see if it was the cause for problems I am having but now I forgot what side was where. Or it doesn't matter?
By gorgorsan Sun Aug 14, 2011 3:17 am
Hi, yes RAM. I think it can go both ways as both sides are identical. The only difference is that one side has the sticker over chipsets.
By MPCdawk Sun Aug 14, 2011 5:21 am
gorgorsan wrote:Hi, yes RAM. I think it can go both ways as both sides are identical. The only difference is that one side has the sticker over chipsets.


Check the pins - the RAM will not be the same if it is turned around one way and then the other. Slot in between some of the pins will be in a different place, and one end also has a notch that needs to be put at the right end of the slot as well.
By gorgorsan Sun Aug 14, 2011 5:38 pm
OMG, what an embarrassing question :oops: . It was in the middle of the night and I was in a hurry and didn't notice that notch at one end. Thanks anyway for answering the dumbest question of all time guys :o .