any way to force Full Level as a default setting?

Hi. I would like to set Full Level ON as a default setting when the unit powers on and auto loads. Is there any way to force this?

(alternatively, is there any way to set globally all pads to V.Level = 0 ? )

uhhh just push the button every time it turns on? its just one button. under program you can set the velocity range but it doesn't work the way you think it would. it just doesnt play any pad strike that exceeds or falls short of the involved parameters. only tip i got is that you can modify the velocity of any strike in the sequencer afterward, maybe that'll help you get where you're going.

so there's no way, even with the alternative JJ firmware, even with some hidden setting, that can force Full Level to on whenever the unit is powered on?

my mpc remembers the state of the full level button when i turn it off and back on. mpc2500se, jjosxl 2.30

my button is broke, so that FULL LEVEL stays pressed nonstop! LOL, not sure if this could be considered a work-around for what you want? lol...

joshonefive wrote:my button is broke, so that FULL LEVEL stays pressed nonstop! LOL, not sure if this could be considered a work-around for what you want? lol...

you look at it as a glass half full I guess

YO!

just push the **** buttin dude!

out of all the things to complain about, you have to choose one of the few things which there is a DEDICATED button for...

ok i missed your button is broke.. sori but the topic is heatable to me

search broken buttons, n swap it for a button you dont use like one of the q buttons or something, coz i doubt it would be a solder job, rather a plastic broken button switch.. peace!

padlock wrote:just push the **** buttin dude!

n i'll be the first to admit how that typo sounded

**** wrote:my mpc remembers the state of the full level button when i turn it off and back on. mpc2500se, jjosxl 2.30

Yup, noticed that too (mpc1k), neat.