New Thick Fat Pads for the Mpc1000 issue.

I just purchased the new thick fat pads for my mpc 1000 and when i put them on it seems like they dont sit right... The bottom pad row are nice and tight and above the bottom row they seem to be really lose but all the male rubber pins go in the hole lined up does anyone have the same problem?

The top pin was trying to pop out during my install, but I just made sure to put the case back on slowly so the top rubber guide pin didn't pop out. (probably what happened with your sheet.)

but are your pads kinda lose or are they all tight sitting?

Progeny210 wrote:but are your pads kinda lose or are they all tight sitting?

No, they're in there tight. Like I said, I just had to be extra careful the sheet didn't pop up underneath the casing, when I put it back on. To be more specific, I laid the casing over the pad sheet from the front first, and pressed the top of the sheet down as I finished lining up the top casing.