MAYDAY: How To Save A Program As A Default?

Technical questions for the MPC2000xl and the MPC2000
 Reply Share on Facebook
User avatar

MAYDAY: How To Save A Program As A Default?

By Gadget Mon Sep 19, 2011 11:40 am
Good day all,

I've had this problem for ages and I've had enough of it... over the years I've searched the manual, this site and the net, but nothing!

I'm using the 2000XL and everytime I switch it on I have to reprogram the pads to play in a scale like order (Pad: 1-16 = Note: 35-50 and so on...) or load a pre-saved program and go form there. The latter works fine, but it gets abit much when you have to load the program from a disk every single time as opposed to just switching on and getting on with it.

So how can we save a program as a default so that everything's in place after the MPC(2000XL) is switched on?
User avatar

Re: MAYDAY: How To Save A Program As A Default?

By Lampdog Mon Sep 19, 2011 1:25 pm
You can't your only option is to continue doing what you've been doing, load a program you've already created with the pads in the order you want them to be and use autoload so that program will load up when you turn on the mpc IF the media is already inserted.
User avatar

Re: MAYDAY: How To Save A Program As A Default?

By Gadget Mon Sep 19, 2011 2:54 pm
Respect Lampdog, Don Blake just holla'd as well and basically said the samething you said. Funny thing is I did the autoload thing by mistake earlier but wasn't sure what I did until I heard from you both. Well, on the bright side it's still a few seconds quicker with the autoload and i don't have to do anything!

Thanks for your help!
 Reply
Return to MPC2000xl, MPC2000