By MPC2K500
Fri Jun 01, 2012 1:59 pm
Bug fixes:MPC2500 OS-XL Ver3.19 01-JUN-2012
---------------------------------------------------------------------
1. [MIDI CLOCK]
When the [PLAY] button is pressed, a song position pointer is not outputted.
2. [Registration of patterns]
[NAME]
The name set immediately before does not become the next default name.
3. [PATTERN]
A setup of "Pad to MIDI note out" is not reflected.
4. [FOOTSWITCH]
When [F6] is assigned, STOP by a foot switch does not work by a record mode.
5. When the value of the transpose of a pattern is changed during recording, it is recorded without reflecting a transpose.
6. If LOOP & HOLD hit a pad in truck mixer mode during a play, LOOP & HOLD will stop.
7. [TRIM]
[Loop ON]
When the key is locked, F3 (Zcross) button adjusts a loop point in the window of JOINT, and when a window is closed, the start point of the sample is not linked.
8. [TRIM]
An error message will not be displayed but MPC will be reset, when a memory is insufficient and "COMBINE A+B" is performed.
9. [GRID]
[MOVE]
A bar will be added, when region selection is made to END and an event is moved back.
10. [MIDI/SYNC]
[BUTTON]
A note cannot be chosen from a controller when a channel is set up.
---------------------------------------------------------------------
1. [MIDI CLOCK]
When the [PLAY] button is pressed, a song position pointer is not outputted.
2. [Registration of patterns]
[NAME]
The name set immediately before does not become the next default name.
3. [PATTERN]
A setup of "Pad to MIDI note out" is not reflected.
4. [FOOTSWITCH]
When [F6] is assigned, STOP by a foot switch does not work by a record mode.
5. When the value of the transpose of a pattern is changed during recording, it is recorded without reflecting a transpose.
6. If LOOP & HOLD hit a pad in truck mixer mode during a play, LOOP & HOLD will stop.
7. [TRIM]
[Loop ON]
When the key is locked, F3 (Zcross) button adjusts a loop point in the window of JOINT, and when a window is closed, the start point of the sample is not linked.
8. [TRIM]
An error message will not be displayed but MPC will be reset, when a memory is insufficient and "COMBINE A+B" is performed.
9. [GRID]
[MOVE]
A bar will be added, when region selection is made to END and an event is moved back.
10. [MIDI/SYNC]
[BUTTON]
A note cannot be chosen from a controller when a channel is set up.
