Is there a way to turn off velocity on MPC 1000?

Im running JJ OS. Is there a way to turn off velocity sensitive on the pads so each sample I play is at max level? How do I do it? : )

Thanks

Don't take this the wrong way, but you just about everything in the manual has been covered on the forum multiple times, the search function is your friend.

"Search found 6034 matches
Search term used: +velocity"

wow

there is a button on the upper right corner labeled "full level" press that.

And a less obvious tip is holding the 'full level' button and turning the jog wheel allows you to set a specific constant velocity other than max which is useful. At least it does in XL...

go into GPE, there should be a velocity column (forget if it's called velocity, probably) and by default it's set to 50. use this for program-by-program velocity=>amp control, this is more granular than using full level.

complementary information

VELO (The curve of volume against velocity is determined.)

When this value is low, by a velocity, volume is wide range changes.
When this value is high, by a velocity, volume is narrow range changes.
When this value is 100, it always becomes the same as a velocity 127.

http://www7a.biglobe.ne.jp/~mpc1000/os2xl/gpe_amp.htm

Which version are you using by the way?