Discuss the various methods you use in music production, from compressor settings to equipment type.
User avatar
By tunnelno5 Wed Aug 01, 2012 10:53 pm
yo, sampled via turntable -> dj mixer -> mpc2500. 45rpm + 8. i can't tell if i sampled this a little too hot, i usually push it till the meter on the dj mixer reads light red on 0db.



load it up into the mpc, tune down 7, sorry fam
Last edited by tunnelno5 on Thu Aug 02, 2012 8:12 am, edited 1 time in total.
User avatar
By Lampdog Wed Aug 01, 2012 11:01 pm
tunnelno5 wrote:........push it till the meter on the dj mixer reads light red on 0db.


If it barely touches red every several seconds it should be good imo.
User avatar
By tunnelno5 Thu Aug 02, 2012 12:04 am
usually when i sample at light red, the sample usually sounds okay however,i feel like with the one i posted earlier (or link 1 below), the high note chords crack a little bit? my ear is sort of untrained, so i thought i'd post up here. if you could listen to the examples, much love!
User avatar
By jonestown massacre Thu Aug 02, 2012 11:50 pm
What does the meter on the 2500 show you when you sample in? On the XL it shows digital meters... If the meters peak, you are clipping. You can record the DJ mixer with the gain settings all the way up, channel faders all the way up, but have the gain set very low on the MPC and not clip.

If you are asking if the DJ mixer is clipping, it would depend on the DJ mixer (digital/analog). If its an analog DJ mixer (99.9% it is) you CANNOT clip the signal, you can only distort the signal. Clipping happens when you input more power (higher dB) than the available dynamic range/maximum input level of the digital signal processor is rated for. (EG:-50 dbu into a DSP rated for a max of -40dBu). The dsp just eliminates (aka "clips") everything above the max input level....

In an analog circuit, the outputs are distorted because the circuit must accept the voltages it is being supplied and pass them through the device. Distortion (depending very much on the analog device being used) can be sound good and be used as an effect. Many people seek the "saturated, lo-fi tape sound...", they are looking for an analog circuit that distorts signal in a specific way.
User avatar
By Ill-Green Fri Aug 03, 2012 1:09 am
:lol: :lol: don't give me that bullshit about having a an untrained ear because you play violin gotdammit.

The red on the meter should never be hanging for long periods, it should appear from time to time but not frequent. The meter should be bouncing in the green and occasionally hitting red from -4dB to 0dB. Always use your ears jackass, yeehaw.