By Jamon
Wed Aug 29, 2012 6:27 pm
XL 3.20 (MPC2500)
In trim mode, Q1 and Q2 sliders control absolute start and end positions.
Q3 and Q4 should control relative positions outside the start and end points.
So if you move Q2 slider to the middle of a sample, then turn Q4 all the way to the left, it will be at the position set by Q2 location. But as you turn it to the right, it increases in small steps.
This would allow you to move the slider right before the sound with bigger movements, then turn the knob above it to get closer with smaller movements.
In trim mode, Q1 and Q2 sliders control absolute start and end positions.
Q3 and Q4 should control relative positions outside the start and end points.
So if you move Q2 slider to the middle of a sample, then turn Q4 all the way to the left, it will be at the position set by Q2 location. But as you turn it to the right, it increases in small steps.
This would allow you to move the slider right before the sound with bigger movements, then turn the knob above it to get closer with smaller movements.