[BUG][SOLVED] switching from os1 back to osxl

So, i switched between those two, and now if i want to load a sample to a pad, the screen where i set the sample not showing, only the "load sample" screen.
Thats sucks because, i must go to main screen and set the samples by pushing the pad i want and scroll down the list of samples i was loading in the programm.

Hi,
First of all, after switching os it is recommend to keep ERASE at start-up. If you use a recent version of os2xl you can save and reload the system setup. It's very handy in this case.

Otherwise did you check if you have this option set to ON?

Sample to load is assigned to a pad.



If the [WINDOW] button is pushed in the mode of LOAD, a "Option" window will open.


When the setup here is "ON", if loading of a sample is performed, the window of "Assign to Pad" will open.


Please move cursor to the pad number which wants to assign the sample to load, and press the F5 (YES) button.
When the F4 (NO) button is pressed, it does not assign to a pad.
And a window is closed.

http://www7a.biglobe.ne.jp/~mpc1000/os2xl/saveload_3e.htm

Thx man, thats done the trick.
Problem solved.