Question on Assigning chop samples to different banks 1k

I got my sample chopped and I created a program,the sample was assigned to each pad with no problem. So now I go to chop the second half of sample than create program select bank B thinking it will load in bank B, but that did not happen. Some how the second chop sample replaced the first chopped sample. So my question is what am I doing wrong? Can someone please explain how this should be done thanks in advance!

I think you are saving new program with same name, so this means it will save over old program, and that would erase old one and replace with new one.
You really want JJOSXL NDC (non destructive chop) it will make your work a dream.

So if you want to make samples go on to another BANK then it is the SAME program just different BANK. So no need at all for a new program then, just assign the samples to the pads manually after you have chopped them. Simple. Hope that helps.

@ bliprock thanks man I figured it
out but reading your response made it a lot easier to understand. Thanks for your help!

not a prob gearhead glad to help.