I assigned FX1: 4 Band EQ to Pad 1 & 2
I assigned FX2: 4 Band EQ to Pad 13
FX:1 slot: When I adjusted the MID2: to 500 -5 Q:10
The entire overall sound started screeeetching a very high frequency. When I completely turned the FX:1 off, the screeching stopped. All other effects within FX:1 would work but when I scrolled back to EQ, it would screech again.
FX:2 slot: Assigned to pad 13. Worked fine, no issues when adjusting 4 Band EQ parameters.
Pads 1&2 only had LPF freq @ 85; Reso @ 30. No other changes were made to these pads. These were both 2 bar samples.
I am running Version 1.17
Edit: This has happened twice. The only way to make it stop is to save Entire Memory and shut off MPC and turn back on, and it will load without screeching anymore.
I assigned FX2: 4 Band EQ to Pad 13
FX:1 slot: When I adjusted the MID2: to 500 -5 Q:10
The entire overall sound started screeeetching a very high frequency. When I completely turned the FX:1 off, the screeching stopped. All other effects within FX:1 would work but when I scrolled back to EQ, it would screech again.
FX:2 slot: Assigned to pad 13. Worked fine, no issues when adjusting 4 Band EQ parameters.
Pads 1&2 only had LPF freq @ 85; Reso @ 30. No other changes were made to these pads. These were both 2 bar samples.
I am running Version 1.17
Edit: This has happened twice. The only way to make it stop is to save Entire Memory and shut off MPC and turn back on, and it will load without screeching anymore.