Some bugs on mpc 60

Hello everebody! I bought an mpc 60 mk1 with 3.10 os about month ago and sometimes i'm being confronted with some bugs. Sometimes when i hit a pad it can play its sample with another sound from different pads or banks. And once i was playing on pads when mpc played sequence and when i changed sequence channel was changed from "off" to "1a" and i couldn't play pads. But when i stopped it became to "off". What is it? I heard that 3.10 got some problems may be this bugs are typical or my mpc comes to death? There floppy emulator drive, can it be a reason of bugs?
Sorry for my english if it got mistakes.

Make sure your pads are not set to trigger other pads

Check your midi settings

I don't think you have any bugs
It sounds like you just need to learn how to use it mate

Beatdiggerjazzcat wrote:Make sure your pads are not set to trigger other pads

Check your midi settings

I don't think you have any bugs
It sounds like you just need to learn how to use it mate

That pad which played sample from another bank were not set to trigger other pad

Initialise (reset) all the PARAMETERS, which are stored in non-volatile memory. Could be something in there you are not aware of.

I'd reseted parameters but this bug with double triggering still annoying me... It's a bug...

a bug is O.S. related, this sounds like a possible pad sensor sheet issue, if you already intialized the 60.

If it was a bug, all of us with 3.10 would have the same problem right? So its not a bug, probably your pad sensors need cleaning or replacing. Or there is a ghost in your machine...

i really should look at the sensor sheet, maybe you can check the ribbon cable, if the lines are messy / corrupted maybe you can gently clean them, otherwise change it for a new one.
i had the same issues, after instaliling a new sheet all problems were gone.

Thank you! I will try it!