Hey, I got a problem.....

While installing the firmware I noticed screen saying looking for software, which I assume is normal operational procedure. Came back about 20 minutes later and the MPC screen is blue and the bottom Four pads are lit... RED GREEN GREEN YELLOW.

I started the prededure over same thing. Now the hardware for my renaissance is none functional. Is there a way to revert back to it's previous state?

Your answer is here:
viewtopic.php?f=36&t=168764

Ok..... After retrying over and over, it finally worked. That was strange!

mjames4208 wrote:Ok..... After retrying over and over, it finally worked. That was strange!

Did you retry the emergency update or what?
I've been doing that many times, no luck.

Naw.... I just unplugged everything and plugged everything back up (everything meaning USB connections) over and over again and finally it took....

mjames4208 wrote:Naw.... I just unplugged everything and plugged everything back up (everything meaning USB connections) over and over again and finally it took....

You mean after the update, you did the unpluggery and finally the blue screen went away and it was alive again?

The 1.5 update was effortless..... The firmware is what gave me a hard time.