Missing samples

JBM wrote:This is currently happening to me as well. Has anyone figured out how to fix to this issue?

All of my previous saved drums and sampled sounds play just fine that are saved on my hard drive.

The Problem:
Sampling Sounds from Vinyl: Saving and Re-Loading issue in MPC Ren OS1.5

I sampled drums from my MPC3000 into the MPC Ren. The drums play and trigger fine in PGM sequence of a beat prior to saving and after. However when I save and close out the beat then load up the beat again at a later time. The newly sampled sounds are missing on the Assigned pads. The Sounds are located in the entire Beat Folder and they are labeled but no audio plays for the saved sounds.

Make sure the MPC Software/Preferences/Other/Sampling Bit Depth is set to either 16 or 24.

@SimonInAustralia Thank You!!! For some reason my Sample Bit Depth wasn't set to neither 16 or 24. Once I selected 16 and resampled the sounds and saved them they all played back and trigger just fine as a saved PGM.

Good catch Simon!

It was posted as a solution to the same problem in another thread.