MPC 1000 playing back wrong sample HELP!

Hey everybody.
I'm sure this has been covered somewhere before, but I can't find it, and my session is on hold until I can figure this out!

So I have the free JJOS, and created some programs with MPCMAID. I followed someone on some forum's advice and messed with the default note value assign when creating programs in MPCMAID. I believe I did some kind of chromatic setting instead of the default MPC layout.

Now when I sequence a part using one of those programs, the sound I want is triggered by the right pad when I hit it, but a different sample plays back from the sequence.

I would prefer to fix this on the MPC itself rather than redoing the programs in MPCMAID and transferring them again.

I have tried switching the midi/drum setting of the track and going into the midi settings and pressing "reset" to get default note values back. No luck, and I can't find anything in program mode that changes this.

How can I adjust the overall note layout within the program or tell the sequence to play nice with the program as it is?

Oh help...

Free JJOS can save everything, I think.
So what's going on in step is that it records the same note as the pad that I hit, but that note is assigned to a different pad, so that pad's sound gets played. I record one in bank C and one in bank A is triggered by the seq.

Someone hooked me up with a tip on here a while back so I'll pay it forward.
Pad11. Note. Whole. Window. 35-98. Done!