lost my second pair of effects!

ok WTF. just dropped in some extra memory and the 8 outs board and the second effects pair have disappeared from my effects page. only 1 and 2 are there.



If from my Multi i try route a program through C or D or CD, i only get silence. A or B or AB have no issue. this is even if

I went into global and it say the board is installed. did a reboot, no luck.

did >Global>Initial to initialize all parameters.

any ideas?


***************



only 2 fx in 96k


***************

i was gonna say: reduce sampling frequency.

Lampdog wrote:It's not uncommon, rather normal flow of things unless I'm misunderstanding you.

+1

Use 44.1Khz and you're good.