How to reduce/remove bass line from sample in ableton.

I'm working on a track and already have my own bass line, the sample chop's I'm using are a sting / horn section but which also has a bass line which obviously is clashing with my own one, which ableton audio effects would I use to try and get rid of the bass line from the sample?

Have you already tried a hipass filter? This is the first thing you should try but without hearing what exactly is goin on in the original sample I can't give advice that work 100%.

If you don't mind, send me the sample (PM) and I'll probably can help more.

peace

Cheer's for the reply, the sample is the seven minutes of funk break, don't know if you know it.

Oh yes I know that tune. The bass seem to be run thru one of these stompbox FX. An envelpoe filter in this case (just like the guitar in the beginning of "God make me funky") This filter amplifies the more higher bassfrequencies and creates some "smacking" noises. I just loaded it into my audio editor and played around a bit. With a highpass filter with steep curve and a frequency at something like 380Hz you can get rid of most of the bass without killing the horns too much (the strings are playing in a complete different range and will be unaffected). But there is a lot of other stuff goin on in this track. Epiano, guitar the drums. IDK how you want it to sound and what other samples you mix it to but when I cut out the bass like in this case I also put a lo pass filter or a high shelf EQ on it to smoothly get rid of the higher frequencies that often sound a bit harsh (to my ears).

peace