By bhambrabland
Sun Dec 14, 2014 1:29 pm
For those of you out there who are having trouble with the MPC Software error drive A: not ready, close door... Here is the solution...
Step 1: Click cancel, many times, until your MPC Software launches, and it will after a bunch of cancels... (it took roughly 10 cancels for mine to launch)
Step 2: Look towards top left where it has 5 folder icons, with folder icon 1 selected use the drop down arrow below these icons to navigate to a new folder where your stuff is saved, can be any location
Step 3: Once at your favourite folder hold down SHIFT on your keyboard and then click on the folder icon 1 again (this will save that new folder location as the default for that folder icon)
Step 4: Repeat the above steps 2 and 3, and change all folder icon numbers to a new location other than A: (You may find your software freezes when selecting a new folder icon number and you will have to hit cancel a bunch of times again until it unfreezes and you are able to navigate to your new folders for that number)
--
Hope that makes sense.
PS, I updated my software after doing this and had to do it all over again, so if you are new to the software like I am, update it as soon as you are able to do that, and then do the above if you are getting this error. Saves you time lol
Right now I have to figure out how to use this MPC Studio!
Blandy
Step 1: Click cancel, many times, until your MPC Software launches, and it will after a bunch of cancels... (it took roughly 10 cancels for mine to launch)
Step 2: Look towards top left where it has 5 folder icons, with folder icon 1 selected use the drop down arrow below these icons to navigate to a new folder where your stuff is saved, can be any location
Step 3: Once at your favourite folder hold down SHIFT on your keyboard and then click on the folder icon 1 again (this will save that new folder location as the default for that folder icon)
Step 4: Repeat the above steps 2 and 3, and change all folder icon numbers to a new location other than A: (You may find your software freezes when selecting a new folder icon number and you will have to hit cancel a bunch of times again until it unfreezes and you are able to navigate to your new folders for that number)
--
Hope that makes sense.
PS, I updated my software after doing this and had to do it all over again, so if you are new to the software like I am, update it as soon as you are able to do that, and then do the above if you are getting this error. Saves you time lol
Right now I have to figure out how to use this MPC Studio!
Blandy
