MPC-2000 classic (part # to order for SCSI fuse)

Hi Folks
Any idea of part # to order for SCSI fuse?
(My MPC 2000 classic will not see a Zip drive (SCSC ID6 and Termination set to On)
Im using a standard DB25 25 pin printer cable --i assume that cable should be ok as it was tested on another MPC 2000.)


thanks in advance
David B

first of all, don't use scsi ID6.. use one of the other options.. preferably 1. termination on.

here is the mpc 2000 service manual which shows all the spare parts (and fuzes) you might need:
https://www.sendspace.com/file/6c3f22

Using ID#6 will give you problems.
Try using ID#5 before rushing to fit a new fuse. Fitting the fuse involves some basic soldering skills.

sorry my bad ---Zip drive is set to SCSI ID 5 and Termination ON
thanks to link to service manual

There is also an auto-reset fuse that some have used, so you don't have to replace it if you blow it again.

Have you checked to make sure that the fuse is actually blown (continuity or voltage)?