By linee
Sat Jun 13, 2015 2:13 pm
pretty new to the mpc1000 but i've searched around and can't find anything on this...
basically my qlink sliders have complete stopped working . they were initially working fine (if tiny little bit jittery sometimes) and now randomly i can't get any value out of them. if i change the value of say, the low range of a TUNE type, i still get the effect. i just can't get the sliders to actually alter this
so, could i have done something to turn off their functionality or has the actual hardware of the sliders themselves died? maybe some parameter buried a couple of menus in that i've switched on and forgotten about.
seems like a weird coincidence that they've BOTH stopped working at the same time with no warning (intermittent failures etc.)... so possibly a dumb mistake?
THANKEE
basically my qlink sliders have complete stopped working . they were initially working fine (if tiny little bit jittery sometimes) and now randomly i can't get any value out of them. if i change the value of say, the low range of a TUNE type, i still get the effect. i just can't get the sliders to actually alter this
so, could i have done something to turn off their functionality or has the actual hardware of the sliders themselves died? maybe some parameter buried a couple of menus in that i've switched on and forgotten about.
seems like a weird coincidence that they've BOTH stopped working at the same time with no warning (intermittent failures etc.)... so possibly a dumb mistake?
THANKEE
