How to Loop Sample

I created my first samples in Live and am learning how to edit them. I assign samples to pads and select loop forward, forward reverse, etc. but it only plays as a one shot no matter the setting.

I see when you select "Trim" the A pads light up allowing different ways to play the sample, one of which is continuous which I am guessing is what I want.

Is this a bug or am I missing something?

Go into program edit and turn Loop on. Did you turn Loop on?

Also its not a trigger loop, you would have to hold the pad down for successful looping.

First set the sample to Loop (fwd, alt or rev) in SAMPLE EDIT.

Then in PROGRAM EDIT > LFO MODULATION set sample play to NOTE ON.

Ok, that's fine. But how can i get a sample to loop without holding the pad all the time? What I am looking for is a toggle mode!

Only available in CLIP programs.

How do i exactly turn loop mode on it is like this ?PROGRAM EDIT > LFO MODULATION set sample play to NOTE ON because i dont see this Go into program edit and turn Loop on when i go into program edit?Thanks

The 16th pad is the 'loop' pad, just hit it once (in sample edit mode).
Is this what you meant?

DonnyDank wrote:The 16th pad is the 'loop' pad, just hit it once (in sample edit mode).
Is this what you meant?

Yes. Thanks.

Using the 16th drum pad to loop worked thank you.

Main page Track 01>Transpose set to 1.
Program 001>Warp samples>
Global tab>note on.
Samples tab>pad loop on.

For different drum loops, I include them in the same mute group to alternate back and forth.

DonnyDank wrote:The 16th pad is the 'loop' pad, just hit it once (in sample edit mode).
Is this what you meant?

This.