Q-link problem

Hi guys has anyone else noticed the q link knobs (mpc live) sometimes becoming unresponsive since updating the firmware? I need to cycle through the columns and then they work again.

Not that one specifically, but I find various bits and pieces of the software can become randomly unresponsive with no way to knowingly recreate, so a bit difficult to submit bug reports on them .

Emergingstates wrote:Hi guys has anyone else noticed the q link knobs (mpc live) sometimes becoming unresponsive since updating the firmware? I need to cycle through the columns and then they work again.

According to Dick Trap aka Andy from Nukai this is intended and a nod to Nukais iconic design flaws (MPC 1000 pad fail, MPC 5000 smoking screen fail, MPC 2500 tact switch fail, etc.) of the past.

Ultimately this is what Nukai is known for, so they are staying true to themselves.