Help! SCSI conflict on ID#6

New to the MPC production world? Got a music production question that's not really specific to any particular MPC? Try your luck here and get help from our experienced members.
 Reply Share on Facebook

Help! SCSI conflict on ID#6

Bydrumlord Sat Jan 15, 2005 8:55 pm
I recently got a 2000xl-mcd. When I hooked an iomega 100mb zip drive to it, I tried to test it by formatting a disk. When I hit "format" I get this message: SCSI conflict on ID#6. No "do it" icon appears above F6 as it should either. I also get this when I simply scroll to another device (ie SCSI-1 to SCSI-2). I have no problem loading sounds from the multi card drive. Am I hooking up the zip drive incorrectly? Is it an internal problem with my MPC? Any help would be greatly appreciated as the manual does not contain anything about this.
User avatar

By BRAVO Sat Jan 15, 2005 9:05 pm
What SCSI ID is the drive set too...Change that to 2

Bydrumlord Sun Jan 16, 2005 6:25 am
BRAVO wrote:What SCSI ID is the drive set too...Change that to 2


I tried setting it to two and didn't have any luck. As soon as I turned the jog wheel I got the same message.
User avatar

By Phatz Mon Jan 17, 2005 10:17 pm
on the back of the zip drive flip the little black switch from 6 to 5 and you will be str8.......dont put nothing on 6

Bydrumlord Tue Jan 18, 2005 5:44 am
Phatz wrote:on the back of the zip drive flip the little black switch from 6 to 5 and you will be str8.......dont put nothing on 6


Thanks Phatz. Works fine.
User avatar

By Phatz Tue Jan 18, 2005 9:11 am
No doubt Drumlord......

Happy Bangin'
 Reply
Return to Getting Started With MPCs