richie wrote:@Plasticlegs could you post your configuration scsi2sd configuration file / settings that were done with the util?
On the General Settings tab I left everything to it's default - SCSI Host Speed Normal; Startup Delay 0; SCSI Selection Delay 255 and everything below Unchecked.
Device 1 Enable SCSI Target checked, SCSI ID (I used 0, you can use that or 1 or 2, you just can't select 6 because that's the channel the MPC uses); Device Type Hard Drive; Quirks Mode None; SD card start sector 0 (this changes with each device added, see next paragraph for details); Sector size (bytes) 512 Sector Count 2097152; Device size 1 (Below I indicated GB though the MPC recognizes less than 600MB); Vendor and Product ID are whatever words you want to appear during boot; Revision is 4.2 and Serial Number is whatever defaulted. The only fields not default that I changed are the SCSI ID and the Device size.
For the remaining 3 device settings you do the same thing (just pick a SCSI ID number one up from the last, so my Device 2 was SCSI ID 1, Device 3 SCSI ID 2, Device 4 SCSI ID 3) but remember to check the Auto tab beneath the SD card start sector field so it can populate that automatically. It will advance the sector start point based on the previous SCSI ID's device size.
Once everything is set, just Save to the Device and your setting will be set up on the SCSI2SD.
Everything is default. The only things you'll change are the SCSI ID and the Device size for each of the 4 virtual hard drives, remembering to chick the Auto tab beneath the SD card start sector to advance where the current device can be found on the SD card.
Hope this helps.