MPC Ren both stereo outputs at once?

Is it possible for Ren to output to both stereo outputs (1/2&3/4)? I would like to use two pairs of monitors, one on the 1/2 and other on 3/4. I know you can set each separate program to output on the assignable mix outs, but then it is quiet on the main outs...

How would one go about that? Thanks!

Will have a look later. Wife's in the office atm.
Did you try assigning all outputs from your audio interface ?
If so any programs set to play from outputs 3-4 should come out of the corresponding chanel.

Not really looked into that side as I normally use 16/32 outs from the plugin into reaper
Likewise for routing. Never delved into the mpcs routing.

I have the outputs set as active in MPC software under audio settings. However, I don't seem to be getting anything out of 3/4 in standalone MPC Software, unless I assign the program - but I just want the stereo out.

It does work in Reaper though, however it would be ideal if I could control the 3/4 outs with the MIX/COMP knob on my MPC. Still experimenting

Thanks for answering

Only been playing with my ren for about a month now but could you have a send from the master to chanel 3/4?

Forgot to look last night. Ended up recording a 15 minuite gin fueled live jam with a project. Just upgraded to 2.7 from 1.9 and sussing out how to utilize clips