fx returns

What about using assignable outputs to your hardware and returning the signal from the hardware back to the input of the mpc, resample in the sampling screen or looper and blend this audio with the original signal.

ralphyartis' wrote:What about using assignable outputs to your hardware and returning the signal from the hardware back to the input of the mpc, resample in the sampling screen or looper and blend this audio with the original signal.

That's not a good option when using tape delay because the resample option using the sampler doesn't start when the sequencer starts.. which will cause the delay to be off timing

Why not returning the fx output to the Mpc input and record it as audio track?
Anyway I use a mixer for that, a Mackie 1220i which sends the mixer channels to computer via firewire.
So I have 3 stereo outputs, 1/2 master, 3/4 and 5/6 to hardware fx and to mixer, all from mixer to a multitrack.

Quickstrike2.0 wrote:
Unless there's something I'm missing.

Is this not an option?

EnochLight wrote:Is this not an option?

With the options that Quick presented, the issue is that the MPC SOFTWARE doesn't have Delay Compensation for sending a signal and recording back into the MPC SOFTWARE on time.

I didn't catch that he was running a REN in controller mode. My bad. Indeed, a proper DAW with PDC is the way to go.