MPC X Screen Burn? Was I just unlucky?

I always turn my mpcx off when i’m done. Screen saver is set to kick in after idle for 2 minutes and i just noticed this. Apparently I’m on the grid edit page too much. This is some bullshit.

When you turn it off and turn it back on it still shows up?

just curious...

BeatWilson wrote:When you turn it off and turn it back on it still shows up?

just curious...

i shut her down after i posted earlier and turned it back on just now. it’s gone... for now.

IMO I think this is sorta how the screen "works" cause i can create slight lines if i try but im honestly im mostly in the main screen. i dont see those bars or lines from that paint anywhere. The only ones i can create are the yellow ones in pad perform.

I believe these lines are not permanent. Like as you shut down and reboot in minutes it should be gone. Im assuming ofcourse....

It does not bother me. But also i actually do not like bright lights at all, even on music gear... like my rane 72 lights are bright asf.... stupid if you ask me.... theres no option to turn that down, but there is an option for the night mode in the mpc, that is what i run on now.

bright screens can **** right off...