Firmware 2.8.1 Assign sample to pad issue

Hi there
I cant figure out what the hell i am doing wrong while assigning slice to pad!
Got a sample. Trim manually.
Got a drum prog setup to assign specific trimmed slices.
I assign slice 1 to pad a1 non destructive within drum prog. Sample loaded ok
I assign slice 2 to pad a2 non destructive within same drum prog but now pad a1 sample is replaced with slice 2 of the manually trimmed sample
Sample converted & assigned to pads are being replaced each time with new slice i am converting..

What am i doing wrong? Im sure im doing something silly..
Thanks

I think it's a bug. Just adjust the right slice to the right pad manually

Ok thanks. But do you do this? Am i not already assigning manually??

That's the same bug that's happening on my Live, except when I'm assigning notes to the pads in a midi program. I'll assign a note to a few pads and when I go back and check like hald of the previously assigned pads notes will change to a different note. WTF.

Ok so best is to downgrade to 2.7.2 so, am i right.
Seems SIT wasnt does completely when releasing update. A beginner oversight for a tech implementation.. unreal.

wookieewookiee wrote:Ok so best is to downgrade to 2.7.2 so, am i right.
Seems SIT wasnt does completely when releasing update. A beginner oversight for a tech implementation.. unreal.

What's worse is that they've had months to fix this and nothing. Plus there's many other bugs from 2.8 that remain, all have been reported through official channels etc. I would have thought these would have been priory fixed, instead they've since released MPC beats with the same bugs.

wookieewookiee wrote:Ok thanks. But do you do this? Am i not already assigning manually??

I let it do it automatically by 'Converting' Slices to a Program