By assarhaddon
Sun Nov 15, 2020 2:25 pm
Hallo, I wonder if anyone could help me. I wrote to customer service but never received any answer. I have a pretty big problem between my live mpc and the mpc software.
I use the mpc as a MIDI transmitter to my keyboard and rhythm boxes through different ports, usually MPC A and MPC B. Since the installation of the penultimate updated software and new firmware in the mpc, software and hardware are incompatible.
When recording a sequence with its respective midi out in MPC A or MPC B with the software connected, when disconnecting it and opening the "Standalone" project, it does not remember which are the recorded outputs and this box is blank.
if instead I save the project in the MPC "Standalone" when opening the project in the software the MIDI OUT indicates "MPCLive Controller MPC MIDI Port A or B " output that does not exist
this means that in neither case can I hear the sequence until I manually change the ports
I have reset the ports, renamed and reinstalled the software and drivers several times already without any results.
Thank you in advance for your help.
I use the mpc as a MIDI transmitter to my keyboard and rhythm boxes through different ports, usually MPC A and MPC B. Since the installation of the penultimate updated software and new firmware in the mpc, software and hardware are incompatible.
When recording a sequence with its respective midi out in MPC A or MPC B with the software connected, when disconnecting it and opening the "Standalone" project, it does not remember which are the recorded outputs and this box is blank.
if instead I save the project in the MPC "Standalone" when opening the project in the software the MIDI OUT indicates "MPCLive Controller MPC MIDI Port A or B " output that does not exist
this means that in neither case can I hear the sequence until I manually change the ports
I have reset the ports, renamed and reinstalled the software and drivers several times already without any results.
Thank you in advance for your help.