SD card not showing up in MPC ONE

my san disk ultra , 128 gb isnt getting read by my mpc one, is 128gb too big? thank you

128gb is not too big... do you know what format your SD card is? There might be a format that it doesn't support on the card.

NearTao wrote:128gb is not too big... do you know what format your SD card is? There might be a format that it doesn't support on the card.

could this be the problem? theres some files that have .asd files https://prnt.sc/wcjvpy

i also got folders inside folders could that be the problem? https://prnt.sc/wcjxnw

That's just showing that your computer can see the drive, not what the format is...

I should ask... are you using controller mode and it is not showing up (not supported on the MPC One... ugh)... or are you in standalone mode and it does not show up?

ri scott wrote:my san disk ultra , 128 gb isnt getting read by my mpc one, is 128gb too big? thank you

No. Your MPC One will read it. Just format it.

NearTao wrote:That's just showing that your computer can see the drive, not what the format is...

I should ask... are you using controller mode and it is not showing up (not supported on the MPC One... ugh)... or are you in standalone mode and it does not show up?

i only have the power supply on, i think im on standalone, yeah, it dosent show up

justineastwick wrote:

ri scott wrote:my san disk ultra , 128 gb isnt getting read by my mpc one, is 128gb too big? thank you

No. Your MPC One will read it. Just format it.

sorry this seems like a dumb question, but how do i format it? do i just out it in the sd slot?

NearTao wrote:That's just showing that your computer can see the drive, not what the format is...

I should ask... are you using controller mode and it is not showing up (not supported on the MPC One... ugh)... or are you in standalone mode and it does not show up?

how do i change modes?