MPC One not sending MIDI program change to Roland JD-XI

I've changed the JD-XI to ....
- ProgRx/Tx Ch = 16
- Tx Edit Data = On
- Sync Mode = Slave
- Clock Source = USB (because I've plugged USB out of JD-XI into MPC USB.)
- USB Drv = Generic

I set a MIDI program on the MPC One
- MIDI port = JD-XI MIDI 1
- Program CH = 15 (Roland JD-XI uses hex numbers. So 16 Hex = 15 decimal.)

And in preferences set the MPC One to send MIDI clock and MMC. And Program Change to Program.

In theory ... when I press play on the MPC One it should start the Roland JD-XI, both running at the same BPM. Instead though, nothing happens. I've got a Beatstep Pro that controls the JD-XI, so I know it works.

I am at least able to send MIDI notes back and forth from between the MPC One and the JD-XI, but that's it.

Any ideas how to fix this ...? I would certainly appreciate. And hello everyone! I'm new here, and a new MPC One owner.

Might be too obvious, BUT:

Under Preferences > MIDI/SYNC did you press the SYNC button next to the corresponding MIDI out?

P.S.: I am standalone ATM, can‘t check in software prefs.

THAT'S IT!!!

83dude, you're as knowledgeable as you are handsome. Thank you!

Glad I could help, thanks.

EDIT: Honestly, your description was sufficiently thorough to spot where you might have forgotten something. Well played, sir.

Remember: source > target > amount

Actually, 16 Hex equals 22 decimal.

Hexidecimal goes from 0 through 9 and A through F so F Hex equals 15 decimal.

ThinkerThunker wrote:I've changed the JD-XI to ....
- ProgRx/Tx Ch = 16
- Tx Edit Data = On
- Sync Mode = Slave
- Clock Source = USB (because I've plugged USB out of JD-XI into MPC USB.)
- USB Drv = Generic

I set a MIDI program on the MPC One
- MIDI port = JD-XI MIDI 1
- Program CH = 15 (Roland JD-XI uses hex numbers. So 16 Hex = 15 decimal.)

And in preferences set the MPC One to send MIDI clock and MMC. And Program Change to Program.

In theory ... when I press play on the MPC One it should start the Roland JD-XI, both running at the same BPM. Instead though, nothing happens. I've got a Beatstep Pro that controls the JD-XI, so I know it works.

I am at least able to send MIDI notes back and forth from between the MPC One and the JD-XI, but that's it.

Any ideas how to fix this ...? I would certainly appreciate. And hello everyone! I'm new here, and a new MPC One owner.