By PPlastic
Tue Apr 12, 2022 7:55 am
Hello, I'm fairly new here, so hope this message is ok and on the right board.
I've been trying to setup a workflow for making tracks. I start sketching on my MPC One with my MicroFreak and WaveState attached via USB midi Hub and all working fine and dandy in standalone.
Then when I need to lay out and fine tune a full length piece I wanted to move to controller mode and use the longer timeline / easy of final edit and processing in the MPC2.0 software to make this easier.
The issue is when I switchover to Controller Mode none of my usb midi devices show up.
I've tried looking everywhere online and checking manuals to find similar issues / check if what I am trying to do is possible but with no luck.
I'm on all the latest updates for both firmware and software.
I've tried to show to midi ports in both modes below, not sure if it helps.
(The USB DEVICE 0x944 is how the Wavestate likes to identify itself)
I've been trying to setup a workflow for making tracks. I start sketching on my MPC One with my MicroFreak and WaveState attached via USB midi Hub and all working fine and dandy in standalone.
Then when I need to lay out and fine tune a full length piece I wanted to move to controller mode and use the longer timeline / easy of final edit and processing in the MPC2.0 software to make this easier.
The issue is when I switchover to Controller Mode none of my usb midi devices show up.
I've tried looking everywhere online and checking manuals to find similar issues / check if what I am trying to do is possible but with no luck.
I'm on all the latest updates for both firmware and software.
I've tried to show to midi ports in both modes below, not sure if it helps.
(The USB DEVICE 0x944 is how the Wavestate likes to identify itself)