Custom arp pattern info

Yesterday I copied the 3000 arp patterns to the arp pattern folder, as per instructions on kikgens GitHub.
Problem then is, that the Mpc must cache em all into memory as it boots, with all that lot there it took 5 minutes to boot up every time.
They worked ok, with plenty of time spent scrolling through em.
Also a firmware update overwrites them.
Ah well.

Hi Wul,

I thought it was impossible in Standalone, only with the software. I'm surprised.

Rank31 wrote:Hi Wul,

I thought it was impossible in Standalone, only with the software. I'm surprised.

Yea it’s possible in standalone, just needs to be ssh enabled firmware.

https://github.com/TheKikGen/MPC-LiveXp ... -and-Force

Custom Arps can be Midi files?

Its the same thing with too many progression files. Temporally freezes on boot and whenever you switch to progression mode. It seems like something seriously has to go wrong that loading such little relative data causes such a spike in resources. I did find that an error in a single file causes problems as the MPC is using resources to scan it and ignore if its bad. You should check to see if all your midi files are good. Maybe that helps maybe not.