Mpc x Sampler not work

Hi need help!?My sampler don't Records my sound/sample!? i hear music what im gonna sample but volumeMeter not show anything and If play Records it's tell me no signal? can somebody give me some help with this problem??

Have you turned Monitoring on?

Have you selected the correct inputs?

Which MPC are you on?

Are you in standalone or controller mode?

How have you connected the source audio to your MPC?

Are you using a USB audio interface?

Probably more questions... but nobody is going to be able to help you with the limited information you have provided.

I work standalone right now and i use RCA aux cable with My phone input 1&2 and everything Work really good but middle of My beat session something happend sampler volumeMeter not pump like It did before this problem and If i try to recored its tell me not signal My soundcard Works fine and speakers Also. My mpc Model IS mpc x

Check the Line/phono. If it’s set to phono then switch it to line.

Switch the MPC off, unplug power cord. Move the on/off switch a couple of times to discharge capacitors in PSU and on main board. Wait a moment.
Plugin the power cable again and start as usual.
This procedure often clears internal hickups if a unit performs strange.

It's possible you've got your MPC X hardware monitoring turned up, but haven't turned your software monitoring on.

That's just my guess though.

Hey Dada,
Here's the thing, the rca input is only for phono, if you turn the switch to line, you need the 6,3mm plugs. I wondered also about that, but its described in the manual, rca is only for phono.
Seems senseless , but thats it.
Hope i could help,
Best regards