By mpcxpurity
Sun Feb 12, 2023 6:24 pm
Hey What's up guys,
I recently purchased an MPC X used, and it was running version 2.10, so I decided to upgrade it. I figured my MPC live was successful, might as well try the X.
I used the wifi method, downloaded the image and it went into update mode. I left the house only to return two hours later with the MPC X still in update mode. I waited a bit longer just to see, so i made the mistake of cleaning around the studio and unplugged the cable because I forgot that I had connected it to my power conditioner on the desk, not the one on the floor. Well long story short, my MPC X will not get passed the loading screen.
I've tried searching these forums for a solution. I opened a ticket with Akai, most likely wont hear from them until tomorrow. I notice this happens a lot with the Lives and Ones, haven't seem much on the MPC Xs.
Did anyone else have this problem? If so, what did you do to resolve it?
I recently purchased an MPC X used, and it was running version 2.10, so I decided to upgrade it. I figured my MPC live was successful, might as well try the X.
I used the wifi method, downloaded the image and it went into update mode. I left the house only to return two hours later with the MPC X still in update mode. I waited a bit longer just to see, so i made the mistake of cleaning around the studio and unplugged the cable because I forgot that I had connected it to my power conditioner on the desk, not the one on the floor. Well long story short, my MPC X will not get passed the loading screen.
I've tried searching these forums for a solution. I opened a ticket with Akai, most likely wont hear from them until tomorrow. I notice this happens a lot with the Lives and Ones, haven't seem much on the MPC Xs.
Did anyone else have this problem? If so, what did you do to resolve it?
