buttons start to fail on the mpc one

Like on my old 2500 on my one the buttons start to fail, I have to press hard to trigger the MAIN button
Is it as easy as on the 2500 to replace the buttons on the one? I never opend mine.
Which buttons should I order?

My main button failed soon after I go the Mpc one . Akai did f..k all . So I opened it up, traced everything out, and found an open circuit between the main button and the chip it was supposed to be connected to , eventually found the solder pad had lifted off the circuit board on one of the button terminals after numerous failed attempts to repair I did manage to solder a connection and glue the terminal to the board. Still ok.
You can see when a button is pressed the terminals moving away from the board.
Very very shoddy pcb construction .

Wul wrote:My main button failed soon after I go the Mpc one . Akai did f..k all . So I opened it up, traced everything out, and found an open circuit between the main button and the chip it was supposed to be connected to , eventually found the solder pad had lifted off the circuit board on one of the button terminals after numerous failed attempts to repair I did manage to solder a connection and glue the terminal to the board. Still ok.
You can see when a button is pressed the terminals moving away from the board.
Very very shoddy pcb construction .

I've had my MPC One since launch and use it practically daily. Zero issues with any of the buttons. Just wanted to throw that in there...

what partnumber of tact switches should i order?
I used these on my 2500:

https://de.farnell.com/alps/skhhaka010/ ... dp/1656423