Possible q-link bug in 2.13 MPC Live2

Just updated and spent 2 hours on a new sequence. First, the q-links window kept popping up when using jog wheel, without any contact with q-links. After another half hour, now the q-links window stays on screen and the touchscreen doesn't work. I can go into menu screen ok and that functions. If I turn off the q-links window in Prefs, it's fine, but I want to see what I'm editing, I'd rather see that window.

Can anyone confirm please, thank you.

Did you reset your preferences?

I'll try this out soon.

I'm not seeing it.

Could be the touch on one of your knobs is going bad.

Could be a ground fault. Try unplugging it from the wall and running it from the battery to see if it gets better.

I thought about resetting Prefs, but wanted to wait as it's a hassle setting it up again.

I did try restarting the unit and the issue didn't come back. But it was only on for few minutes after that.

Shouldn't be a faulty cap as I've hardly used it and it's less than year old. But you never know! Hope it's not that!