Booting in controler mode

Couldn't find any ways to be able to boot directly in controller mode.
Could be useful and time saving.
Is it possible?

It should boot into whatever mode it was in when it was last turned off.

MPC-Tutor wrote:It should boot into whatever mode it was in when it was last turned off.

+1 I only use a MPC One as a controller and it boots Into controller mode when I power it on.

Thanks for your feed back.
I’m aware that the MPC boots back in the state you left it. A good point.
But my question is more about « forcing » the start up in one specific mode.
Holding a combination of button when powering on.
Do not know if it has been implemented . But this would save powering on the MPC twice to boot in the desired mode.