Support and discussion for all of Akai’s modern standalone MPCs including the MPC X / X SE, MPC Live 1, 2 & 3, MPC One / One+, MPC Key 37/61.
By Modern Groove Assembly Sun May 05, 2024 2:28 am
Hi friends.

I'm sending MIDI to Kontakt Standalone via an AMT8 Midi Interface.

On one sequence, as soon as I hit play on the MPC, it changes the Kontakt volume to zero.

I tried opening up a blank project and it works fine, and I tried some different sequences in the old project and it works fine, so my thought was it must be some automation event somewhere on one of the channels in this particular sequence. I muted all the channels but that didn't help. Even with all the channels muted, it still sends the volume message to Kontakt.

If I manually reset the volume in Kontakt while the sequence is playing, it stays in place when the sequence loops again, so it makes me think it's not an event somewhere in the automation of one of the tracks. For some reason, when I hit play, somewhere it's sending a volume message to Kontakt and the Kontakt output goes to zero.

Any idea why it's doing this or how to fix it?
User avatar
By Lampdog Sun May 05, 2024 3:58 am
On mpc, go into LIST EDIT and look around at the first bar of affected track.
There is a volume change or track mute recorded there somewhere.
By jamos Sun May 05, 2024 5:39 pm
Make sure each MIDI channel you are usiing has a unique MIDI program. Track volume will then control the external instrument consistently; make sure it is not set to zero.
User avatar
By Lampdog Sun May 05, 2024 5:50 pm
Is the external device at fault?

PREFERENCES give any insight as to what could be happening.
By Modern Groove Assembly Tue May 07, 2024 4:06 am
Thanks for the help, I copied everything to a new sequence and then started deleting the tracks one by one. I found an unused MIDI track that somehow had the volume set to zero and that's what was causing it to go to zero. That explains why it didn't show up in the event menu.

In the words of the great beatsmith Homer Simpson, "Doh."