How to connect computer to MPC and interface

Hi all,

I have a Macbook Pro that I would like to connect to my MPC one as well as an interface. For the interface I have a UAD Volt 476p (4 in/4 out) that I would like to connect to both my computer and MPC at the same time. Is this possible? I don't have a mixer and would rather not have to buy one at least not right now. I also have some studio monitors that I would like to be hooked up too all of this but I figure I can probably just plug those into the interface. Any tips on signal path here would be much appreciated. Thank you!

I would imagine that there are a few ways to hook these three up.
I like the (midi) old school ways, so I would connect the Volt to the Mac via a USB cable.
Then I would connect the MPC to the Volt using two 5-pin Midi cables: Out>In and In>Out.
As for the audio, I would then connect two cables, left and right, from the MPC main out, to the Volt input 1 & 2 (or 3 & 4).
And I’m assuming you have the Volt connected to some audio amplifier that in turn is connected to two speakers or perhaps it’s connected to some amplified speakers?

I'll try this out, thanks!! I appreciate the reply