Cannot enter ratio with keyboard in OPx-4

Unless I use OPx-4 within MPC (either as app or as VST) on Windows. Then a double click lets me enter a value.

If I use OPx-4 within my DAW (Reaper) or as an app, then this is not possible. Creating or fine-tuning a patch is impossible.

Is it just my setup?

Masi wrote:Unless I use OPx-4 within MPC (either as app or as VST) on Windows. Then a double click lets me enter a value.

If I use OPx-4 within my DAW (Reaper) or as an app, then this is not possible. Creating or fine-tuning a patch is impossible.

Is it just my setup?

I was about to ask the same question! You can set ratio 1.0000 exactly with the mouse but its impossible to set it to 2.0000, always off a few hundred of .01s. This is ridiculous.