MPC 3.5 Standalone Bug Reports

Here's something I do quite frequently. MPC One, fw 3.5

I start with a new project and set SEQ length to 4, for example. Record a drum track shall we say.
Next I think I want that to loop at 4 bars while record the next track, (which I plan to create in a moment) longer, let's say 16 bars.
So I turn "SEQ" off. Track and seq length both 4 still.
Next I adjust SEQ length to 16. Track length follows it so track length is now 16.
Then I have to go back and set track length to 4 which is where I wanted it to begin with which is why I turned "SEQ" off.

Reported to Akai.

I just got a message that my reported midi bugs where resolved. I think i got it a while ago once.
Does that mean anything?

There is a bug in the sample editor when zooming in fully

1. Open any sample in Sample Edit mode
2. Zoom in 100%
3. Select start or end value field
4. Turning the Data Dial now increases and decreases the selected value by 2 instead of 1
5. Pressing the + and - Buttons now increase and decrease the selected value by 2 instead of 1

Never had this issue on older MPCs, they all move in increments of 1 (as expected) when turning the main data wheel when zoomed in fully

Please sort this out Akai

ck4000 wrote:There is a bug in the sample editor when zooming in fully

1. Open any sample in Sample Edit mode
2. Zoom in 100%
3. Select start or end value field
4. Turning the Data Dial now increases and decreases the selected value by 2 instead of 1
5. Pressing the + and - Buttons now increase and decrease the selected value by 2 instead of 1

Never had this issue on older MPCs, they all move in increments of 1 (as expected) when turning the main data wheel when zoomed in fully

Please sort this out Akai

Akai has nothing to do with this site. Did you file a ticket?

B-Wise wrote:Akai has nothing to do with this site. Did you file a ticket?

I filed it about 5 times over the last couple of years, each time I was basically told the details were passed on. Nothing further.
Very disappointing , have given up reporting it to them

ck4000 wrote:

B-Wise wrote:Akai has nothing to do with this site. Did you file a ticket?

I filed it about 5 times over the last couple of years, each time I was basically told the details were passed on. Nothing further.
Very disappointing , have given up reporting it to them

I just wanted to make sure you knew this isn't an official Akai site.

Is anyone else experiencing a tuner calibration bug? No matter where I set “Frequency of A”…300, 400, 440, 500, the calibration still tunes to A 440.