By Chekov
Wed May 27, 2026 4:43 pm
Hi, i have a MPC one withe the firmware 3.8 in standalone mode and i try to connect my JU-06 a via y-audio cable to the mpc. There is only sound when i set the input to 1 not to 1/2 where the cable is in i. In my minifuse Audio controller. i can see, that there is only on the right chanel a signal coming in (while over input one and output 1/2). In the project under main in the Strips on the left (audio 001 and output 1/2) there is written on output 1/2 : NO OUTPUT ROUTING chose another teb.
Have anyone an idea how to fix this?
Have anyone an idea how to fix this?
