Scsi conflict??????

I havent used my mp in a few days and when I try to load the scsi it says scsi conflict on ID#6. My scsi is set to 5 and the termination is off. Can you tell me why it still says this and how to fix it.


Thanks,

If it is only your MPC and zip connected then the terminater needs to be on , that might help.

Iomega makes crappy cheap consumer products. That is not only my opinion but also anyone familiar with that industry. The ID switch is more like an internal button. Even though it may show 6, it may not actuate. Flip it a few times.