Running My MPC As A Slave With My (LAPTOP)

Hey Everyone,
PLEASE HELP, is it posible to Hook up the MPC2000XL to Pro Tools on my (LAPTOP) so that the MPC is the slave. AND WHAT DO I NEED?

Yo. this is I think the fifth separate post for the same topic.

Eventually someone who knows about this will chime in on this dun. But you have to stop reposting this. This is all one forum that connects to all the other sections of the forum.

So someone who understands what you are tryin to do will eventually chime in. What you can do if you dont want the post to go unanswered is reply with a "bump".

Literally click reply and type bump. So that your post stays at the top so people can continue to check it out until someone with knowledge of your situation responds.

Check out the stickies. Because what you are doing might get you banned.


EMFinite

Dreward wrote:Hey Everyone,
PLEASE HELP, is it posible to Hook up the MPC2000XL to Pro Tools on my (LAPTOP) so that the MPC is the slave. AND WHAT DO I NEED?

Midi Leads, midi interface and setting the MPC to slave and to recieve input on the midi socket u have plug it into. then setting PT to br master. you might need to offset the time a bit t make it sync right. this being 00.00.00