
By Boogie Man
Thu Oct 02, 2003 7:55 pm
For along time I thought about buying a mixer with at least 24 channels because I have the 8 outs on my piece plus I got 8 outs on my sampler. I found a very cheap and much less expensive way of using them. Buy couplers. Buy using 3 couplers you can put 4 cables into 1 input line of your mixer. Now you still have 7 other line inputs to use. 6 couplers = 8 cables and 2 line inputs. << this is how I now use my samplers 8 outs. I can mute these from the MPC. So with 6 couplers, I use the 8 outs of my sampler into 2 line inputs with leaves me with 6 remaining line inputs available. 6 more couplers using the 8 outs on my MPC and using 2 more line inputs leaves me 4 line inputs to still use. So its like I have 16 separate channels going into 4 line inputs. This makes the mute function on my MPC that much more valuable. Each coupler is about 5 bucks from Radio Shack. So to cover all 16 outs on the MPC and my sampler, I'd spend roughly 60 bucks. I think this is alot better than spending at least 700 bucks on a mixer, even though theres nothing wrong with that. This is just a less expensive way of going down the same route minus the bussing, etc. So, for the heads with not alot of bread to breakup, hope this might help your situation.
http://www.soundclick.com/bands/pagemus ... ndID=32110
http://www.myspace.com/locomotivez
The man with the $25 1200!!!
The only jewels I rock are the scars of life!
Go ahead fukcer, tell me what I can't do...then watch me do it...
http://www.myspace.com/locomotivez
The man with the $25 1200!!!
The only jewels I rock are the scars of life!
Go ahead fukcer, tell me what I can't do...then watch me do it...


