mpc 4000 filters

when I load a program in mpc4000, the 2pole filter is always on, I have to go in manually and turn it off on all my samples one by one, is there any way to prevent this from happening, the filter seems to load up when I turn on my mpc

In the page where you change the filter, press the BLOCK CURSUR up two times. In that block, change EDIT:ONE to EDIT:ALL. Now go back to the filter section and change. In this mode, all keygroups or pads will be changed together.

Don't forget to set edit mode back to ONE when you want to change individual keygroups/pads.

tip:
ALWAYS set it back to ":one" right after setting it to ":all" because when its set to all and you want to adjust just 1 sound, everything gets **** up! I had this problem a lot in the beginning.
Also, save a lot so you can load the messed up program back to get the settings right again